Cleaning Your Mask At Home - ResMed Airtouch F20 User Manual

Disassembly
If the mask is connected to your device, disconnect the device air tubing
from the elbow.
1. Undo the fastening tabs on the upper headgear straps. Pull the straps
out of the frame.
Tip: Keep the magnetic clips attached to the lower headgear straps to
easily distinguish the upper and lower straps when reassembling.
2. Remove the elbow from the mask by pressing the side buttons and
pulling the elbow away.
3. Hold the side of the frame between the upper and lower arms. Gently
pull the cushion away from the frame.
Reassembly
1. Attach the cushion to the frame by aligning the circular openings and
pushing together until retained.
2. With the ResMed logo on the headgear facing outside and upright,
thread the upper headgear straps into the frame slots from the inside.
Fold them over to secure.

Cleaning your mask at home

Handwash the elbow, frame and headgear (not the cushion) by gently
rubbing in warm (approximately 30°C) water using mild liquid detergent.
Rinse them well under running water and allow to air dry out of direct
sunlight.
If required, it is recommended to wipe the cushion using CPAP wipes or
equivalent and allow to dry. It is recommended to replace your cushion
every month.
WARNING
• As part of good hygiene, always follow cleaning instructions
(using mild liquid detergent for recommended components and if
required, wiping the cushion with CPAP wipes or equivalent).
Some cleaning products may damage the mask, its parts and their
function, or leave harmful residual vapors that could be inhaled if
not rinsed thoroughly.
English 5