Web Gui Design Principle - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
Step 2. Setup LAN1 IP information
Enter the IP Address and IP Subnet Mask with
192.168.40.254 / 255.255.255.0 and click Apply.
Warning: After you apply the changed settings,
the network will be disconnected instantly since
the network IP address you are logining is
changed.
2.2.2 From CLI (command line interface) to configure MH-5001 LAN1 network settings
Step 1. Use Console port to configure
MH-5001
Use the supplied console line to connect the PC
to the Diagnostic RS-232 socket of the MH-5001.
Start a new connection using the HyperTerminal
with parameters: No Parity, 8 Data bits, 1 stop bit,
and baud rate 9600. Enter admin for user name
and admin for password to login. After logging
into MH-5001, enter the commands "en" to enter
the privileged mode. Enter the command
ifconfig INTF3 192.168.40.254 255.255.255.0" to
change the IP of the LAN1 interface.

2.2.3 Web GUI design principle

BASIC SETUP > LAN Settings > LAN1 Status
ip
"
Figure 2-2 You can select the functional area by the sequence in Web GUI
27
Chapter 2
System Overview