Assembly - ProForm XP 160 831.28645.1 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver
wrench , and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may have been
pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is
missing, call 1-888-533-1333.
Star Washer M4 x 13mm
(92)–3 Washer (93)–2
M10 x 20mm x
1mm Washer
(81)–2
M4 x 16mm
Self-tapping
Screw (79)–10
M8 x 16mm Patch
Screw (95)–3
M10 x 62mm Patch Bolt (89)–4
M6 Split
Washer (88)–8
M10 x 25mm
Washer
(94)–10
M4 x 16mm M6 x 35mm Phillips
Screw (86)–4
M8 x 48mm Patch
Screw (78)–2
, an adjustable
.
M8 Split M10 Spacer
Washer (72)–2
M8 Nylon
Locknut (96)–4
Screw (87)–8
M10 x 20mm Patch
Screw (91)–10
M10 x 78mm Patch Screw (90)–2
5
Wave Washer
(76)–2 (98)–8
M10 Nylon
Locknut (97)–2
M8 x 42mm Bolt
(71)–4
M10 x 23mm Shoulder
Screw (80)–2