ProForm PFSY74490 User Manual page 15

37. Remove the indicated 3/8" Nylon Locknut (50) and
3 1/2" Pulley (24). Wrap the Low Cable (75) around
the Pulley in the direction shown. Reattach the Pulley
and tighten the Nylon Locknut. Make sure the Cable
is routed exactly as shown and that the Cable
Trap (25) is oriented to hold the Cable in place.
38. Attach the end of the Low Cable (75) to the indicated
hole in the Leg Lever (41) with a 3/8" x 2 3/4" Bolt
(46), two 3/8" Flat Washers (48), and a 3/8" Nylon
Locknut (50). Do not overtighten the Nylon
LockNut; the Cable must pivot freely on the Bolt.
39. Identify the High Cable (72). It is longest cable, and
has a ball on one end and a bolt on the other.
Wrap the High Cable (72) over a 3 1/2" Pulley (24).
Attach the Pulley to the Press Top Frame (9) with a
3/8" x 3 1/2" Bolt (56), a 3/8" Flat Washer (48), and a
3/8" Nylon Jam Nut (63).
40. Wrap the High Cable (72) around a 3 1/2" Pulley (24).
Attach the Pulley and a Cable Trap (25) to the Press
Upright (2) with a 3/8" x 3 3/4" Bolt (59), a 3/8" Flat
Washer (48), and a 3/8" Nylon Jam Nut (63).
37
24
38
41
75
46
48
39
40
15
75
25
50
50
48
24
56
48
63
72
72
63
25
48
24
59
2
9