Zenith RC59000M Installation And Operating Manual page 54

Troubleshooting (Continued)
Symptom
Can't play a disc
recorded using this
recorder on another
player.
Cannot record or did
not record successfully.
Timer recording is not
possible.
Stereo Audio Record
and/or Playback is not
present.
The remote control
does not work properly.
Moisture condensation can occur:
• When the VCR/DVD Recorder is moved from a cold
place to a warm place.
• Under extremely humid conditions.
54
Cause
The disc was recorded in Video mode.
Some players will not play even a final-
ized disc recorded in Video mode.
The disc was recorded in VR mode,
Discs recorded with copy-once material
cannot be played on other players.
The remaining blank space on the disc
is insufficient.
The source you are trying to record is
copy protected.
When setting the recording channel, the
channel is tuned on the TV's own tuner.
When recording to a Video mode disc,
programs that are copy-once protected
cannot be recorded.
Clock in VCR/DVD Recorder is not set
to correct time.
Timer has been programmed
incorrectly.
TIMER indicator light does not appear
after programming timer.
TV is not Stereo-compatible.
Broadcast program is not in stereo for-
mat.
VCR/DVD Recorder A/V Out jacks are
not connected to TV A/V In jacks.
VCR/DVD Recorder Audio/Video Out is
not selected for viewing at the TV.
VCR/DVD Recorder's TV audio channel
is set to SAP or MONO.
The remote control is not pointed at the
remote sensor of the VCR/DVD Recorder.
The remote control is too far from the
VCR/DVD Recorder.
There is an obstacle in the path of the remote
control and the VCR/DVD Recorder.
The batteries in the remote control are
exhausted.
Moisture Condensation
Finalize the disc. (page 25)
No solution.
The other player must be RW compati-
ble in order to play it.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the recorder's
built-in TV tuner.
Use a VR mode formatted disc for copy-
once material.
Set clock to correct time. See "Auto
Clock Set" or "Manual Clock Set" on
page 19.
Reprogram Timer. See "Timer
Recording" on page 40.
Reprogram Timer.
No solution.
No solution.
Make A/V connections. Stereo is
available only via A/V output from
VCR/DVD Recorder.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo.
See "Changing TV audio channel" on
page 26.
Point the remote control at the remote
sensor of the VCR/DVD Recorder.
Operate the remote control within 23 ft
(7 m).
Remove the obstacle.
Replace the batteries with new ones.
In locations where moisture condensation may occur:
• Keep the VCR/DVD Recorder plugged into an AC
power outlet with POWER On. This will help prevent
condensation.
• When condensation has occurred, wait a few hours
for the VCR/DVD Recorder to dry before using it.
Solution