Recording - Zenith RC59000M Installation And Operating Manual

Before Operation (Continued)
DV Recorder Audio
You need to set this if you have a camcorder using
32kHz/12-bit sound connected to the front panel DV IN
jack.
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.
On the Audio 1 setting, the sound that was recorded
while shooting is used.
On the Audio 2 setting, the overdubbed sound is used.
DISC Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
Auto Chapter
When recording, chapter markers are put in specified
setting. You can change this interval to 3 minutes, 5
minutes or 10 minutes. If you select None, switch off
automatic chapter marking altogether with the No
Separation setting.
DISC Record Mode
VCR Record Mode
DV Record Audio
Auto Chapter
24
Disc
DISC Initialize
If you're recording on a DVD-R disc, the recording
mode will always be Video mode.
If you load a DVD-RW that has already been used, you
can change this to Recording Mode from the Disc
menu.
If you load a completely blank DVD-RW disc, Disc ini-
tialize menu will appear, to select a desired Recording
Mode to initialize the disc.
Audio 1
Audio 2
Prev. Select
1 1
2 2
3 3
4 4
5 5
Not Use
3 Min
5 Min
10 Min
Select
Prev.
6 6
7 7
If you want to change the disc format, everything
recorded on the disc will be erased.
8 8
DISC Initialize
DISC Finalize
DISC Name
DISC Protect
PBC
Press SETUP.
The Setup menu appears.
Use v / V to select the Disc option.
While the Disc option is selected, press B to
move to the second level.
Use v / V to select the DISC Initialize option.
Press B to move to the third level.
Start icon is highlighted.
Disc Initialize
Select a Mode
Video Mode
VR Mode
Press ENTER.
Disc DISC Initialize menu appears.
Use b / B to select a desired DISC Initialize
Mode (VR Mode or Video Mode) then press
ENTER.
It takes a few moments to initialize the disc.
Caution
Press SETUP to exit the menu.
Start
Prev. Select