Figure 2-5 Composite Wiring Diagram - Honeywell UDC2300 Product Manual

Wiring the Controller
Using the information contained in the model number, select the appropriate wiring
diagrams from the composite wiring diagram below. Refer to the individual diagrams
listed to wire the controller according to your requirements.
Transmitter Power for
4-20 mA 2-wire
transmitters
•
Using Alarm Output
See Figure 2-17
• Using Aux Output
See Figure 2-18
NOTE1:
Neutral
2 Hot
Mains
power
Ground
supply
12/00
Input Terminal
See Figure 2-7
Control Output
Terminals
See Note 1
Mains Power
Supply Terminals
See Figure 2-6
Time Proportional Electromechanical Relay Output – See Figure 2-9
Time Proportional Solid State Relay Output – See Figure 2-10
Time Proportional Open Collector Output – See Figure 2-11
Current Output – See Figure 2-12
External Solid State Relay Output – See Figure 2-13
Three Position Step Control Output – See Figure 2-14

Figure 2-5 Composite Wiring Diagram

PROTECTIVE BONDING (grounding) of this controller
1
and the enclosure in which it is installed, shall be in
L2 / N
accordance with National and Local electrical codes. To
L1
minimize electrical noise and transients that may
adversely affect the system, supplementary bonding of
the controller enclosure to a local ground, using a No.
1
24856
12 (4 mm
Before powering the controller, see "Preliminary
Checks" in this section of the Product manual for
switch and jumper settings.
2 Provide a switch and non-time delay (North America),
quick-acting, high breaking capacity, type F (Europe),
1/2 A, 250 V fuse(s), or circuit-breaker as part of the
installation.
Figure 2-6 Mains Power Supply
UDC2300 Controller Product Manual
8
9
7 10
6 11
5 12
13
4
L2 / N 14
L1 15
16
2
) copper conductor, is recommended.
Installation
Alarm and
Duplex Output
Connections
See Figure 2-15
External Interface
Options Terminals
See Figure 2-16
Input #2 Terminals
See Figure 2-8
24855
13