ProForm PFEL39420 User Manual page 6

1. While another person lifts the front of the Frame (1),
attach a Stabilizer (3) to the Frame with two M10 x
112mm Carriage Bolts (34) and two M10 Nylon
Locknuts (29).
2. While another person lifts the back of the Frame (1),
attach a Stabilizer (3) to the Frame with two M10 x
112mm Carriage Bolts (34) and two M10 Nylon
Locknuts (29).
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (20) to
the Lower Wire Harness (19). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack. While holding the upper end of the
Upper Wire Harness, insert the Upright into the
Frame (1). Be careful to avoid pinching the Wire
Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer
(33) onto the M10 x 88mm Button Bolt (63). Make
sure that the flat end of the Frame Spacer is facing
the Split Washer. Insert the Button Bolt into the
Frame (1) and the Upright (2). Do not tighten the
Button Bolt yet.
4. Connect the wire harness on the Pulse Sensor (35) to
the indicated wire harness on the Console (5). Insert
both wire harnesses into the opening in the bottom of
the Console.
Refer to the inset drawing. Insert the metal tube on the
Pulse Sensor (35) into the metal bracket inside of the
Console (5) as shown. Be careful not to pinch the
wire harnesses. Align the holes in the metal tube with
the holes in the metal bracket, and tighten two M4 x
16mm Screws (66) into the indicated holes.
1
34
3
2
29
1
3
2
63
70
4
5
Wire Harnesses
6
1
29
29
3
34
Make sure the
Wire Harnesses
(19, 20) do not
get pinched and
damaged during
this step.
20
33
19
1
5
66
Bracket
Tube
66
35
35