Pro-Form PFEL29240 User Manual page 6

1. Identify the Front Stabilizer (10), which has round
Endcaps (21) on its ends. While another person lifts
the front of the Frame (1), attach the Front Stabilizer to
the Frame with two M10 x 75mm Carriage Bolts (34)
and two M10 Nylon Locknuts (33).
2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (9) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
3. The Console (23) requires four 1.5V "D" batteries; alka-
line batteries are recommended. Remove the indicated
screw from the battery drawer, and pull the battery
drawer open. Insert four batteries into the battery
drawer; make sure that the batteries are oriented as
shown by the markings inside of the battery draw-
er. Close the battery drawer and reattach the screw.
Note: When the batteries are installed correctly, the fan
will turn on for a moment.
4. While another person holds the Console (23) in the
position shown, connect the console wire to the
Extension Wire (68).
Attach the Console (23) to the Upright (2) with the four
Console Screws (59) included with the Console. Be
careful to avoid pinching the wires.
Attach the Water Bottle Holder (29) to the Upright (2)
with two M4 x 22mm Screws (63).
Turn the Resistance Control (42) counterclockwise
to the lowest setting before continuing.
1
34
34
21
2
33
1
3
Screw
4
Console Wire
59
6
1
10
33
33
9
34
23
Batteries
23
68
42
29
2
63