Maintenance And Troubleshooting - Pro-Form PFEL07907.0 User Manual

Pfel07907.0
Table of Contents

Advertisement

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi-
ately.
For smooth
operation of the
elliptical exer-
ciser, inspect
and clean the
incline ramp
regularly using
a soft cloth and
mild detergent.
Other parts of
the elliptical
exerciser can
also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
see CHEST PULSE SENSOR TROUBLESHOOTING
on page 11.
If the handgrip pulse sensor does not function proper-
ly, see step 5 on page 16.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the elliptical exerciser's incline system is not working
properly, activate the calibration process by following
the steps below.
1. Hold down the Resistance 1 button and the
Program Select button at the same time for about
five seconds. Note: Numbers may appear in the
main display. Disregard these numbers.
2. Press the Program Select button again. Note: A
combination of letters and numbers may appear in
the main display.
3. Press the 30° Ramp button. The ramp will move all
of the way up and then all of the way down.
4. Press the Program Select button three times. The
console will then be in the normal operating mode
and the elliptical exerciser will be ready for use.
HOW TO MOVE THE ELLIPTICAL EXERCISER
Stand in front of the elliptical exerciser, hold the han-
dlebars firmly, and place one foot against the ramp in
the location shown below. Pull the handlebars until the
elliptical exerciser can be moved on the front wheels,
Incline
and carefully move the elliptical exerciser to the
Ramp
desired location. Then, place one foot against the
ramp, and lower the elliptical exerciser. Due to the
size and weight of the elliptical exerciser, use
extreme caution while moving and lowering it.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical
exerciser rocks
during use, turn
one or both of
the leveling feet
under the rear
stabilizer until the
rocking motion is
eliminated.
26
Handlebars
Place your
foot here
Wheel
Leveling
Foot

Advertisement

Table of Contents
loading

This manual is also suitable for:

Club design 800

Table of Contents