Card Reader Board - HP Spectre x360 13 Maintenance And Service Manual

Card reader board

NOTE: The card reader board spare part kit does not include the card reader board cable. The card reader
board cable is available using spare part number 942830-001.
Description
Card reader board
Before removing the card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the card reader board:
1. Release the ZIF connector (1) to which card reader board cable is connected, and then disconnect the card
reader board cable from the system board.
2. Detach the card reader board cable (2) from the keyboard/top cover. (The card reader board cable is
attached to the keyboard/top cover with double-sided adhesive.)
3. Remove the Phillips M2.0×2.8 screw (3) that secures the card reader board to the keyboard/top cover.
4. Remove the card reader board (4).
Reverse this procedure to install the card reader board.
50 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 31).
29).
Spare part number
942829-001