Infrared Sensor Board Cable - HP Spectre x360 13 Maintenance And Service Manual

Infrared sensor board cable

Description
Infrared sensor board cable
Before removing the infrared sensor board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the right fan (see
Remove the infrared sensor board cable:
1. Turn the right fan upside down.
2. Release the ZIF connector (1) to which infrared sensor board cable is connected, and then disconnect
the infrared sensor board cable from the infrared sensor board.
3. Release the infrared sensor board cable from the retention clip (2) built into the right fan.
4. Remove the infrared sensor board cable (3).
5. Remove the infrared sensor board cable.
Bottom cover on page
Fans on page 35).
29).
Battery on page 31).
Component replacement procedures
Spare part number
942832-001
37