Assembly - ProForm 985 Rt User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it has been pre-attached.
Ground Screw (82)Ð1
Console Screw (20)Ð4
M6 x 22mm Button Screw (29)Ð4
M10 x 25mm Button Head Screw (74)Ð10
M6 Nylon Locknut (15)Ð4
M10 Nylon Locknut (45)Ð2
M6 x 38mm Button Bolt (14)Ð7
M8 x 38mm Button Bolt (24)Ð4
M10 X 70mm Carriage Bolt (72)Ð2
M8 x 100mm Button Bolt (63)Ð3
5
and Phillips screw-
M6 Washer (91)Ð3
M8 Washer (90)Ð7
M10 Split Washer (17)Ð10