Brother MFC-J3930DW Online User's Manual page 403

Hide thumbs Also See for MFC-J3930DW:

Table of Contents

If you selected the [WPA/WPA2-PSK] option, press either [TKIP+AES] or [AES].

Enter the WPA key, and then press [OK].

For more information about how to enter text, see the Appendix.

Your Brother machine supports the use of the first WEP key only.

10. The machine attempts to connect to the wireless device you have selected.

If your wireless device is connected successfully, the LCD displays [Connected].

You have completed the wireless network setup. To install drivers and software necessary for operating your

device, insert the Brother installation disc into your computer or go to your model's Downloads page on the

Brother Solutions Center at support.brother.com.

Before configuring your machine, we recommend writing down your wireless network settings. You will need

this information before you continue with the configuration.

1. Check and write down the current wireless network settings.

Network Name (SSID)

Communication Mode

Infrastructure

For example:

Network Name (SSID)

Communication Mode

Infrastructure

If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine

supports the use of the first WEP key only.

[Settings] > [All Settings] > [Network] > [WLAN] > [Setup Wizard].

3. When [Enable WLAN?] appears, press [Yes].

This will start the wireless setup wizard. To cancel, press [No].

4. The machine searches for your network and displays a list of available SSIDs. Swipe up or down or press a

or b to display [<New SSID>]. Press [<New SSID>], and then press [OK].

5. Enter the SSID name, and then press [OK].

For more information about how to enter text, see the Appendix.

6. Press [Infrastructure] when instructed.

7. Select the Authentication Method.

8. Do one of the following:

Authentication Method

WPA/WPA2-PSK

Authentication Method

Encryption Mode

Encryption Mode