Adjusting The Brake Effect - Invacare Rea Dahlia 30 Service Manual

Pos 1 — 16"–22" wheels
Pos 3 — 16"-20" wheels
See "Seat height tables" in section "Technical data"
for a more detailed information.
Change position
Change position from an upper placement of the attachment
(pos 1 and 3), to a lower placement (pos 2 and 4):
C
A
1. Loosen and remove the screws A and the nuts B.
2. Remove the brake attachment with the brake C from
the chassis.
6 mm Allen key
3. Loosen and remove the screw and the washer D.
6 mm Allen key
4. Remove the brake from the brake attachment F.
5. Be careful not to loose the nut E which is located inside
the brake attachment F.
1572308-G
Pos 2 — 22"-24" wheels
Pos 4 — 16"-20" wheels
6. Turn the brake attachment F 180 degrees.
6 mm Allen key
7. Re-mount the brake on the turned brake attachment F.
8. Remember to re-insert the nut E if this was removed
from the attachment.
9. Re-mount the screw and the washer D.
10. Tighten the screw with 10 Nm.
A
11. Re-mount the brake and the attachment C on the lower
position on the chassis.
12. Re-mount the screws A and the nuts B.
13. Tighten the screws with 5 Nm.
6 mm Allen key
When changing the position from pos 1–3 or pos
2–4, steps 3–10 are excluded.

3.22 Adjusting the brake effect

Brake type 1
The distance A between the pin B and the tire C
should be max. 2 mm.
Settings and Adjustments
C
A
B
C
35