Adjusting The Depth Of The Central Legrest - Invacare Rea Dahlia 30 Service Manual

Screw for foot angle adjustment
A
1. Loosen the rear screw A on the side of the tube.
Tools: 5 mm Allen key
2. Adjust the legrest to the desired angle.
3. Retighten the screw.
4. Repeat this procedure to adjust the angle of the other
foot plate.

3.16.3 Adjusting the depth of the central legrest

1. Loosen the frontal screw A on the side of the tube.
Tools: 5 mm Allen key
2. Adjust the depth of the foot plate.
3. Tighten the screw A when you have found the desired
depth.
4. Repeat this procedure to adjust the depth of the other
foot plate.
3.16.4 Adjusting the angle of the central legrest
A
1. Loosen the adjustment knob A.
2. Hold the foot plate with the other hand.
3. Adjust to the appropriate leg angle.
4. Re-tighten the knob.
WARNING!
Risk of trapping fingers
When adjusting the foot plate, the fingers might
get trapped.
– Loosen the adjustment knob with one hand
and hold the foot plate with the other hand to
avoid trapping yours or anyone else's fingers.
CAUTION!
Risk of damage
The legrest might cause damage to the floor.
– When the seat is tilted forwards on a chair
with a long legrest length and low seat height,
there is a risk of the legrest hitting the floor
and causing damage.
1572308-G
3.17 Adjusting the calf pads
1. Swing the pad forwards.
2. Unscrew screw A.
A
3. Remove the large nut C on the reverse side and place it
4. Move the calf pad to the new position.
5. Secure it into place with the screw A and the nut C.
3.18 Assemble the posture belt for positioning
3.18.1 Assemble posture belt to front attachment
When using the posture belt for positioning of the knees,
the front attachment slot A can be used.
A
Tools: 5 mm Allen key
in the second attachment hole.
Belts/harnesses which are CE-marked for the purpose
of using on wheelchairs, can be mounted on the
chair with preserved CE-marking. The belt/harness
should be fitted by the responsible prescriber and be
mounted by an experienced technician. However,
when transporting the wheelchair in a vehicle,
Invacare's original pelvic belt must be used as a
complement to the safety belt in the vehicle!
The purpose of using the posture belt as a positioning
help is to position the user and to give him / her a
better posture.
The posture belt should be placed in the front
attachment bracket when used for positioning of the
thighs/knees.
The posture belt should be placed in the lower slot
on the backrest attachment bracket when used for
positioning of the thighs.
A
Settings and Adjustments
C
33