Advertisement
P
P
ROPERTIES
2 5 B
The Properties page shows the current status of the UT. A description of each item on the page follows:
In the top left-hand corner of the screen there are satellite signal strength and beam ID indications. These items
are updated automatically when the status of that item changes.
1.
Registration Status: This field indicates whether you are registered with the network. Click the "Register
with Network" button. Note: For the 9300 Series terminals, bypass antenna pointing is turned on as default,
so it will automatically register with the network each time.
2.
PS Attach Status: This field indicates whether you are Packet Switch (PS) attached with the network. You
will still need to set up a PDP context in order to send PS data.
3.
CS Attach Status: This indicates whether you are Circuit Switch (CS) attached with the network. Once
you are CS attached and registered with the network, you are able to make CS calls.
4.
GPS Position: This field displays the current GPS position status. If you have received a GPS fix and the
network GPS policy has been received and allows the GPS position to be shown to the user, it will display the
latitude, longitude, fix quality, and the last time the GPS position was updated. Time displayed is UTC time.
5.
Emergency Call Numbers: This field displays the emergency call numbers that can be used with the UT.
6.
Software Version and IB Version: These display the current version of software that is running on the
UT. Core module and Interface Board (IB) SW versions are both shown.
7.
Alarms: Any alarms, such as SIM not installed or no antenna connected are displayed.
8.
Satellite Modem IMEI: This displays the IMEI number of the UT.
9.
UE Class: This indicates the UT class, such as Class 10 (high gain) or Class 11 (mid- gain) land mobile
terminal.
10. Satellite Modem IMSI: This displays the IMSI number of the USIM card in the UT. If is the IMSI is not
displayed, it indicates that there is a problem reading the SIM card, for example, because there is no SIM, it is
installed incorrectly or PIN must be entered.
11. USIM PIN Status: This field indicates whether the USIM is ready or the PIN has to be entered. If the PIN
needs to be entered, go to the Setup page.
12. USIM APN Name: This displays the default APN that has been provisioned on the USIM card. Note that
some USIM cards may have multiple APNs provisioned on them.
13. Extract System Log: Clicking this button allows the User to automatically extract a UT system log and save
the file to a location on the TE for debugging purposes. This file can be emailed to Hughes directly for fault
analysis if the User experiences any problems.
14. Download Terminal Log File: This allows you to extract and save different log files.
15. Restore Factory Defaults: Clicking this button will restore the UT back to factory defaults and delete any
of the user parameters that have been set-up in the UT. Hughes highly recommends that the user exhaust all
possible debug procedures before using this feature.
Hughes 9350 BGAN Terminal User Guide
AGE
11
Advertisement
