Intended Audience; Release Notes - Hitachi VSP F1500 User And Reference Manual

Intended audience

This document is intended for system administrators, Hitachi Data Systems
representatives, and authorized service providers who install, configure, and
operate the Hitachi RAID storage systems.
Readers of this document should be familiar with the following:
• Data processing and RAID storage systems and their basic functions.
• The Hitachi RAID storage system and the manual for the storage system
(for example, Hardware Guide, Hitachi Virtual Storage Platform User and
Reference Guide).
• The management software for the storage system (for example, Hitachi
Command Suite, Hitachi Device Manager - Storage Navigator) and the
applicable user manuals (for example, Hitachi Command Suite User
Guide, System Administrator Guide, Hitachi Storage Navigator User
Guide).
• The host systems attached to the Hitachi RAID storage systems.
Product version
This document revision applies to Command Control Interface software
version 01-41-03/xx or later.

Release notes

The CCI release notes are available on Hitachi Data Systems Support
Connect: https://knowledge.hds.com/Documents. Read the release notes
before installing and using this product. They may contain requirements or
restrictions that are not fully described in this document or updates or
corrections to this document.
Changes in this revision
• Added instructions for configuring iSCSI virtual ports
virtual port on page
• Added information about the raidcom get quorum, raidcom modify
quorum, and raidcom replace quorum commands
depending on operation authorities on page
raidcom commands when specifying the virtual storage machine in
HORCM_VCMD on page
• Added information about creating external volumes using iSCSI
external volumes (iSCSI) on page
• Added information about moving a parity group by specifying the LDEV
numbers of virtual volumes of Dynamic Provisioning, Copy-on-Write
Snapshot, or Thin Image
• Updated the error code tables.
xii
5-44,
3-61).
Command Control Interface User and Reference Guide
Deleting an iSCSI virtual port on page
3-13,
5-47).
(Moving parity groups on page
Preface
(Setting an iSCSI
5-44).
(Commands executed
Operation target for
(Creating
5-54).