Show Fmgr Interface - Cisco CRS Command Reference Manual

show fmgr interface

show fmgr interface
To display ternary content addressable memory (TCAM) feature entries for QoS, use the show fmgr interface
command in EXEC mode.
show fmgr interface type interface-path-id feature {policer| qos| qos-all} {input| output} [all| dup-bank|
hw| ipv4-mpls| ipv6| l2| location node-id| sw]
Syntax Description
type
interface-path-id
feature
policer
qos
qos-all
input
output
all
dup-bank
hw
ipv4-mpls
ipv6
l2
location node-id
sw
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
116
Quality of Service Commands on the Cisco IOS XR Software
Interface type. For more information, use the question mark (?) online help
function.
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
Note
currently configured on the router.
For more information about the syntax for the router, use the question mark
(?) online help function.
Displays feature specific information.
Displays policer entries.
Displays QoS entries.
Displays entries for both QoS and policer.
Specifies the ingress direction.
Specifies the egress direction.
(Optional) Displays all TCAM entries.
(Optional) Displays entries from the duplicate bank in turbo mode.
(Optional) Reads from the hardware.
(Optional) Displays ipv4-mpls entries.
(Optional) Displays ipv6 entries.
(Optional) Displays Layer 2 entries.
(Optional) Identifies the location of the interface whose TCAM information
you want to display. The node-id is expressed in the rack/slot/module notation.
Note Use the show platform command to see the location of all nodes
installed in the router.
(Optional) Reads from the software.
OL-23235-03