Match Atm - Cisco CRS Command Reference Manual

match atm

match atm
To enable packet matching on the basis of the ATM operations, administration, and maintenance (OAM) or
cell loss priority (CLP), use the match atm command in class-map configuration mode. To disable packet
matching, use the no form of this command.
match atm {clp [ clp-bit-value ]| oam}
no match atm {clp [ clp-bit-value ]| oam}
Syntax Description
clp
clp-bit-value
oam
Command Default
Packets are not matched on the basis of the ATM CLP or OAM.
Command Modes
Class map configuration
Command History
Release
Release 3.7.0
Release 3.8.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The match atm command is supported on policy maps that are attached to ATM main interfaces, ATM
subinterfaces, or ATM permanent virtual circuits (PVCs). However, policy maps (containing the match atm
command) that are attached to these types of ATM interfaces can be input policy maps only.
The match atmcommand can be configured for ingress service policies only.
Task ID
Task ID
qos
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
34
Configures the ATM CLP bit to be matched. Use either 0 or 1 for clp-bit-value
.
(Optional) Value for the ATM CLP bit. Choose either 0 or 1 as the bit value. If
you do not specify a bit value, the default value of 1 is used.
Configures the ATM OAM to be matched.
Modification
This command was introduced.
The clp-bit-value argument was added.
Operations
read, write
Quality of Service Commands on the Cisco IOS XR Software
OL-23235-03