Connecting Power - Siemens RUGGEDCOM RSG2288 Installation Manual

Chapter 2
Installing Device
Figure 7: Failsafe Alarm Relay Wiring
1. Normally Open 2. Common 3. Normally Closed
Section 2.6

Connecting Power

The RUGGEDCOM RSG2288 supports a single or dual redundant AC and/or DC power supplies.
The RUGGEDCOM RSG2288 can be equipped with either a screw-type or pluggable terminal block, which provides
power to both power supplies . The screw-type terminal block is installed using Phillips screws and compression
plates, allowing either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for secure, reliable
connections under severe shock or vibration.
CAUTION!
Electrical hazard – risk of damage to the device. Disconnect the device from the power supply if power
input is above or below the specified input range. For more information, refer to
Supply Specifications".
NOTE
• For maximum redundancy in a dual power supply configuration, use two independent power
sources.
• Use only #16 gage copper wiring when connecting terminal blocks.
• For 100-240 VAC rated equipment, an appropriately rated AC circuit breaker must be installed.
• For 125/250 VDC rated equipment, an appropriately rated DC circuit breaker must be installed.
• A circuit breaker is not required for 12, 24 or 48 VDC rated power supplies.
• It is recommended to provide a separate circuit breaker for each power supply module.
• Equipment must be installed according to applicable local wiring codes and standards.
CONTENTS
• Section 2.6.1, "Connecting AC or DC Power"
14
1 3
2
RUGGEDCOM RSG2288
Installation Guide
Section 4.1, "Power
Connecting Power