Mounting The Device To A Panel - Siemens RUGGEDCOM RSG2288 Installation Manual

Chapter 2
Installing Device
2
Figure 5: DIN Rail Mounting
1. Panel/DIN Rail Adapter 2. DIN Rail 3. Screw
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.4.3

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM RSG2288 can be equipped with panel/DIN rail adapters pre-installed on
each side of the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
12
3
RUGGEDCOM RSG2288
Installation Guide
1
3
2
Mounting the Device to a Panel