Appendix I - Specifications - Pride Mobility JET 3 Owner's Manual

A P P E N D I X I - S P E C I F I C A T I O N S
Suspension:
Drive Wheels:
Caster Wheels:
Anti-tip Wheels:
1
Maximum Speed:
1,3
Range:
Brakes:
2
Ground Clearance:
2
Turning Radius:
2
Overall Size:
Drivetrain:
4,5
Batteries:
Battery Charger:
Weight Capacity:
2
Component Weights:
1
Varies with base model, user weight, terrain type, battery amp-hour rating (Ah), battery charge, battery condition, motors, controller
type, tire type, and tire condition. This specification can be subject to variance of (+ or -) 10%.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or -) 3%.
3
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculations
based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
4
AGM or Gel-Cell type required. See VI. "Batteries and Charging."
5
Battery weight may vary based on battery manufacturer.
NOTE: This product conforms to all applicable ANSI/RESNA testing requirements and ISO 7176 series
EN12184 standards. All specifications subject to change without notice.
Jet 3 Ultra
JET 3 ULTRA SPECIFICATIONS
Active-Trac
10 in. (25.4 cm) pneumatic or solid available
8 in. (20.32 cm) solid, rear-mounted
6 in. (15.24 cm) solid, front-mounted
Up to 4 mph (6.44 km/h)
Up to 11 miles (17.7 km)
"Intelligent Braking" electronic regenerative, disc park brake
See figure 29.
See figure 29.
Length: See figure 29.
Width: See figure 29.
Two motor, mid-wheel drive
Two 12-volt, deep-cycle, U-1
3-amp, off-board
300 lbs. (136 kg)
Base: 92 lbs. (41.74 kg)
Medium-back Seat: 37 lbs. (16.78 kg)
Batteries: 24.5 lbs. (11.11 kg) each
www.pridemobility.com 45