Pride Mobility JET 3 Owner's Manual page 41

V I I . C A R E A N D M A I N T E N A N C E
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Turn the rear shroud fasteners one-quarter turn in any direction. See figure 6.
4. Remove the rear shroud.
5. Unplug the battery connector. See figure 28.
6. Remove the retaining pin from the foot platform and lift the platform up and away from the power base. See
figure 20.
7. Slide the battery tray forward.
8. Unfasten the reusable strap around the front battery.
9. Disconnect the wiring harness from the front battery.
10. Remove the front battery.
11. Unfasten the reusable strap around the rear battery.
12. Disconnect the wiring harness from the rear battery.
13. Remove the rear battery.
14. Place a new rear battery on the battery tray. Make sure that the terminals are facing forward.
15. Fasten the reusable strap around the rear battery.
16. Connect the wiring harnesses to the rear battery. See figure 28.
WARNING! Use only the quick disconnect harness supplied with your power chair. It has a
thermal fuse on each lead.
17. Place a new battery in the front of the battery tray. Make sure that the terminals are facing toward the rear of
the power base.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
18. Fasten the reusable strap around the front battery.
19. Connect the wiring harnesses to the front battery. See figure 28.
20. Slide the battery tray back into the power base.
NOTE: Make sure that the power pod is out of the way when reinstalling the batteries.
21. Reinstall the foot platform.
22. Reconnect the battery connector.
23. Reinstall the rear shroud and tighten the fasteners.
24. Charge the batteries. See VI. "Batteries and Charging."
Jet 3 Ultra www.pridemobility.com 41