Channel Group Selection - Panasonic WX-CT2020 Operating Instructions Manual

Order taker unit
Hide thumbs Also See for WX-CT2020:
Table of Contents

Advertisement

● Channel Group Selection
You can select a channel group by setting the channel
selector, which is the rotary switch inside the switch pocket.
1. Press the power button to turn off the order taker unit.
2. Set the switch to the channel group.
Available Channel Group: 1 - 8
Notes:
• When a switch position other than 1 through 8 is select-
ed, the power indicator will blink in red.
• Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group will not be activated until
you turn off and on the power again.
1 2 3 4 5 6 7 8
G
5 6
7
4
8
3
2
1
Channel selector
● DIP Switch Setup
An eight-bit DIP switch is provided for system setups. The
initial settings are marked with an asterisk *.
SW#
Function
1
Location
2
3
4
5
6
Tone Squelch
7
Talk Lock Resumption
8
1. Press the power button to turn off the order taker unit.
2. Set the switches as follows.
SW#1: For selection of a radio frequency suitable for
the location
ON: Applies the US frequency to the headset.
OFF: Applies the Canadian frequency.
ON
OFF
USA*
Canada
OFF*
OFF*
OFF*
OFF*
ON*
OFF
ON
OFF*
OFF*
SW#2: OFF
SW#3: OFF
SW#4: OFF
SW#5: OFF
SW#6: This switch selects the mode of Tone Squelch
method.
ON: The audio is output detecting the Tone Squelch
signal from the Center Module.
OFF: The audio is output in disregard of the Tone
Squelch signal from the Center Module.
Note: Normally, set SW#6 to ON. Pay attention to high
level noise that may be output when set to OFF.
SW#7: While talking with a customer in the Talk Lock
mode, you may need to contact store personnel in
the Page PTT or Page Lock mode, which interrupts
the Talk Lock mode. This switch specifies the status
of the interrupted Talk Lock mode after ending the
Page PTT or Page Lock mode.
ON: Resumes the Talk Lock mode.
OFF: Releases the Talk Lock mode.
SW#8: OFF
Note: Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group (refer to "Channel
Group Selection") will not be activated until you turn
off and on the power again.
7

Advertisement

Table of Contents
loading

Table of Contents