Setting The Number Of Rings - Uniden TRU9380 User Manual

Setting the Number of Rings

The ring time setting allows you to set the number of rings the caller hears before your answering system plays the
outgoing message. You can set the ring time to answer after two, four, or six rings. If you enable the Toll Saver (TS)
setting, the answering system picks up after two rings if you have new messages, and after four rings if there are
none. This way, if you make a long distance call to check your messages, you can hang up after the second ring to
avoid long distance billing charges.
1. Press [menu/clear]. Select the ANSW. SETUP menu, and then the RING TIME submenu.
From the
2. Move the cursor to select a ring time (TOLL SAVER, 2 TIMES, 4 TIMES, or 6 TIMES).
handset
3. Press [select/
Setting the Day & Time
If you do not set the clock on your answering system, your messages may not have the correct time and day stamp.
You can set the day and time from the handset or the base.
1. Press [menu/clear].
2. Move the cursor to ANSW. SETUP and press [select/
3. Move the cursor to DAY & TIME and press [select/
From the
4. Use [ ] and [
handset
5. Use [ ] and [
6. Use [ ] and [
7. Use [ ] and [
]
] to select the correct day, and press [select/
] to select the correct hour, and press [select/
] to select the correct number of minutes, and press [select/
] to select AM or PM, and press [select/
39
].
].
].
].
].
]