Table of Contents
Advertisement
Possible cause:
3
1 or 2 TPC sensors have failed
or a system fault has occurred.
34
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Transmission error
with Tire Pressure Control
(TPC)
OE
z
--
-- --
"
" or "
Possible cause:
The motorcycle has not reached
the minimum speed (
TPC sensor is not active
min 19 mph (min 30 km/h)
(The TPC sensor does not
transmit a signal to the motor-
cycle until this minimum speed
has been exceeded.)
Watch the TPC display at
higher speed. A continuous
error is only present if the
general warning light also lights
up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the TPC sensors.
Possible causes are radio sys-
" is indicated.
tems in the surrounding area,
which interfere with the connec-
tion between the TPC/TPC con-
trol unit and the sensors.
105).
Observe the TPC display in a
different environment. A con-
tinuous error is only present if
the general warning light also
lights up. In this case:
Have fault eliminated at a spe-
cialist service facility, preferably
an authorized BMW Motorrad
retailer.
Battery of tire-inflation
pressure sensor weak
with Tire Pressure Control
OE
(TPC)
shows yellow.
appears on the display.
This fault message is only
shown for a short time im-
mediately following the Pre-Ride-
Check.
Possible cause:
The battery for the tire inflation
pressure sensor is no longer
charged to full capacity. Oper-
ation of the tire inflation pressure
control is only ensured for a lim-
ited time.
Contact an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
Advertisement
Table of Contents
