Table of Contents
Advertisement
Use a small, flat-bladed or T8 Torx screwdriver to remove the 3
3.
keyboard screws from the bottom of the computer.
Turn the computer right-side up and open it.
4.
Installing the wireless module
If your computer has a wireless module currently installed, you
NOTE:
must remove it before installing the new module. Refer to Chapter 4,
"Removing an HP Broadband Wireless Module." After you remove the
existing module, begin the following procedure at step 3 to install the
new module.
Remove the tape (1) securing the antenna cables.
1.
8
Chapter 2 Installing the HP Broadband Wireless Module
Advertisement
Table of Contents
