Ricoh Aficio MP W3601 Operating Instructions Manual page 16

1. Getting Started
6. Press [Administrator Tools].
7. Press [Extended Security].
1
8. If you are not using [@Remote Service], set [@Remote Service] to [Prohibit].
For details about "Update Firmware", see the following "Firmware Update Cautions".
9. Press [OK].
10. Press the [User Tools/Counter] key.
11. Disconnect this machine from the administrator-only access network, and then connect
it to the general usage network environment.
Firmware Update Cautions
If IPsec is enabled, all information on the network will be encrypted. This allows you to perform
firmware updates securely.
If IPsec is not enabled, the information on the network may not be encrypted depending on the
protocol. If you want to perform a firmware update when IPsec is not enabled, be sure to do so only
if your network environment is protected against electronic eavesdropping and similar security threats.
• p.35 "Using Web Image Monitor to Configure Administrator Authentication"
• p.186 "Protection Using Encryption"
• p.30 "Registering the Administrator"
• p.179 "Specifying Network Security Level"
• p.172 "Enabling and Disabling Protocols"
14