Cisco ASR 1013 Quick Start Manual page 24

Step 2 The first sections of the configuration script appear only at an initial system startup. On subsequent uses of the setup
facility, the script begins with a System Configuration Dialog as shown below: When asked if you would like to enter
the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended setup
will ask you to configure each interface on the system.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: n
First, would you like to see the current interface summary? [yes]: y
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
GigabitEthernet0/0/0
GigabitEthernet0/0/1
GigabitEthernet0/0/2
GigabitEthernet0/0/3
GigabitEthernet0
Configuring global parameters:
Enter host name [Router]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: test
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: tests
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: test
Configure SNMP Network Management? [yes]: n
Configure IP? [yes]: y
Configure RIP routing? [no]:
Configure bridging? [no]:
Configure CLNS? [no]:
Configuring interface parameters:
Do you want to configure GigabitEthernet0/0/0
Do you want to configure GigabitEthernet0/0/1
24
IP-Address OK? Method Status
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned YES unset
down
down
down
down
administratively down down
interface? [yes]: n
interface? [yes]: n
Protocol
down
down
down
down