TP-Link Archer VR300 User Manual page 56

Chapter 12
8 ) Enter the Pre-Shared Key
Secrecy enabled.
Note: Make sure Site A and Site B use the same key.
9 ) Leave the Advanced
Note: The Status column is
communicating via the VPN connection.
3. Configuration on Site B (remote network). Refer to step 2 configuration on Site A
and make sure that Site A and Site B use the same
Forward Secrecy
4. Check the VPN connection. You can ping site B' LAN IP from your computer in site
A to verify that the IPSec VPN connection is set up correctly.
Tips: To check the VPN connection, you can do the following.
1. On the host in Site A, press [Windows Logo]
2. In the CLI window, type in "ping 192.168.2.x" ("192.168.2.x" can be IP address of any host in Site B). Then press [Enter].
3. If Ping proceeds successfully (gets replies from host in Site B), the IPSec connection is working properly now.
5. Now IPSec VPN is implemented to establish a connection.
for IKE authentication. Then keep
Settings as default value. Then click Save.
Down after the configuration, and it will change to
settings.
+ [R] to open Run dialog. Input "cmd" and hit
VPN Server
Perfect Forward
UP only when Site A and Site B are
pre-shared keys and
OK.
Perfect
52