C H A P T E R 3
O
PERATION
This section describes:
S
S
S
S
S
Turning the UPS On
To turn on the UPS, press the
Figure 11). After the UPS is turned on, it conducts a self-test and enters
Normal mode. The
available from the UPS output receptacles.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the
conduct a self-test to conserve battery power.
Turning the UPS Off
To turn off the UPS, press the
unplug the UPS from the power outlet. If you do not unplug the UPS, it
remains in Standby mode.
Powerware
5115 User's Guide
®
Turning the UPS on and off
Starting the UPS on battery
Standby mode
The UPS front panel and LEDs
Initiating the self-test
µ
button for two seconds. When the UPS starts on battery, it does not
NOTE The UPS does not auto-detect the input frequency when starting on battery; the
default is the last frequency used by the UPS.
www.powerware.com
S
button on the front panel (shown in
i ndicator illuminates indicating that power is
button on the front panel and then
11