Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Powerware 3115
Summary of Contents for Powerware 3115
- Page 1 02/15/01 ® Powerware 3115 User’s Guide 300-650 VA www.powerware.com...
- Page 2 Powerware is a registered trademark of Powerware Corporation. C opyright 1999 Powerware Corporation, Raleigh, NC. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Powerware Corporation.
- Page 3 Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada. Requesting a Declaration of Conformity The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC Declaration of Conformity, contact: Powerware Corporation Koskelontie 13 FIN-02920 Espoo Finland...
-
Page 4: Special Symbols
Special Symbols The following are examples of symbols used on the UPS to alert you to important information: RISK OF ELECTRIC SHOCK associated warning should be observed. CAUTION: REFER TO OPERATOR’S MANUAL additional information, such as important operating and maintenance instructions. -
Page 5: Table Of Contents
ABLE OF 1 Powerware 3115 – One of the Best! 2 Installation ........... . . - Page 6 Table of Contents Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 7: Powerware 3115 - One Of The Best
— causing hours of lost productivity and expensive repairs. With the Powerware 3115, you can safely eliminate the effects of power disturbances and guard the integrity of your equipment. Ideal for PCs,... - Page 8 Powerware 3115 – ONE OF THE BEST 650 VA 300 VA and 420 VA Figure 1. Powerware 3115 Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 9: Installation
Powerware 3115 User’s Guide www.powerware.com ® I M P O R T A N T S A F E T Y I N S T R U C T I O N S... -
Page 10: Installing The Ups
DO NOT protect laser printers with the UPS because of the exceptionally high power requirements of the heating elements. W A R N I N G C (104 F ). Do not operate near water or ° ° Powerware 3115 User’s Guide www.powerware.com ®... - Page 11 On/Off Button Test/Alarm Reset Button Figure 2. Powerware 3115 Front Panel The UPS conducts a self-test and enters Normal mode. If the alarm beeps, consult “Troubleshooting” on page 23. NOTE The UPS charges to 90% in approximately 12 hours. However, it is recommended that the UPS charge for 24 hours after installation or long storage.
-
Page 12: Ups Rear Panels
Installation UPS Rear Panels This section shows the rear panels of all Powerware 3115 models. Communication Port 10A, Resettable Circuit Breaker Power Cord with 5-15 Plug Figure 3. PW3 300 and PW3 420 Rear Panel Communication Port Four 5-15 Output Receptacles Figure 4. - Page 13 10A, IEC-320 Input Connector with Fuse Figure 5. PW3 300i and PW3 420i Rear Panel Communication Port Four IEC-320 Output Receptacles Powerware 3115 User’s Guide www.powerware.com ® Figure 6. PW3 650i Rear Panel Installation DIP Switches Two IEC-320 Output Receptacles...
- Page 14 Installation Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 15: Operation And Configuration
To turn off the UPS, press the unplug the UPS from the power source. If you do not unplug the UPS, it remains in Standby mode. Powerware 3115 User’s Guide www.powerware.com ® ONFIGURATION button on the front panel (shown in... -
Page 16: Standby Mode
3. Plug the UPS into a wall outlet or other power source and press button to turn the UPS on. UPS Rear Panel DIP Switch Detail Figure 7. DIP Switch Location Powerware button on the front panel DIP Switches 3115 User’s Guide www.powerware.com ®... -
Page 17: Communication Port Configuration
To prevent damage to your equipment, connect only a factory-supplied cable or a cable built to factory specifications (see Table 2) to the communication port. A standard serial cable may damage your computer. Powerware 3115 User’s Guide www.powerware.com ® 120V Models... - Page 18 Logic Ground Impending Low Battery: Indicates the battery has less than 2 to 5 minutes of backup time left AC Input Failure: Indicates absence of normal AC input Not Used Not Used Chassis Ground Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 19: Ups Maintenance
If you store the UPS for a long period, recharge the battery every six months by plugging the UPS into a power outlet. The UPS charges to 90% in approximately 12 hours. However, it is recommended that the UPS charge for 24 hours after long storage. Powerware 3115 User’s Guide www.powerware.com ®... -
Page 20: Replacing Batteries
8. Reconnect the power cord to the power source and turn the UPS on. 9. Reconnect the equipment to the UPS. Turn on the equipment one piece at a time. W A R N I N G Powerware 3115 User’s Guide www.powerware.com ®... - Page 21 UPS Maintenance Black (–) Red (+) Figure 9. Replacing Batteries (300 VA and 420 VA models) Powerware 3115 User’s Guide www.powerware.com ®...
- Page 22 UPS Maintenance Black (–) Red (+) Figure 10. Replacing Batteries (650 VA models) Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 23: Testing New Batteries
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead-acid batteries and must be disposed of properly. For more information, contact your local recycling or hazardous waste center. Powerware 3115 User’s Guide www.powerware.com ® button for three seconds to initiate the battery... - Page 24 UPS Maintenance Powerware 3115 User’s Guide www.powerware.com ®...
- Page 25 C H A P T E R 5 PECIFICATIONS This section provides the following specifications for the Powerware 3115 models: Electrical input and output Battery Weights and dimensions Environmental and safety Table 3. Model List UPS Models Table 4. Electrical Input Nominal Voltage 120V default;...
-
Page 26: Specifications
PW3 300: 1 each 12 Vdc battery PW3 420: 1 each 12 Vdc battery PW3 650: 2 each 6 Vdc batteries Type Charging 12 hours to 90% usable capacity at nominal line and no supplementary power supply load Monitoring Backup Time (typical full load) Typical Life... - Page 27 Surge Suppression Meets IEEE 587/ANSI C62.41 Category A Safety Conformance UL 1778; CAN/CSA C22.2, No. 107.1 Safety Markings Powerware 3115 User’s Guide www.powerware.com ® 120V Models (6.1 x 3.4 x 14.6 in) (6.1 x 3.4 x 14.6 in) (6.4 x 4.6 x 14.0 in) PW3 300: 5.2 kg (11.5 lb)
- Page 28 Specifications Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 29: Troubleshooting
The alarm does not silence if there is a UPS fault, low battery condition, or if the battery needs to be replaced. Powerware 3115 User’s Guide www.powerware.com ® button. If UPS... - Page 30 Plug the UPS into a power outlet for 24 hours and then retest. If the alarm persists, contact your service representative. See “Replacing Batteries” on page 14 to replace the battery. The alarm cannot be silenced. Powerware 3115 User’s Guide www.powerware.com ®...
-
Page 31: Service And Support
H H H H e e e e l l l l p p p p D D D D e e e e s s s s k k k k for the dealer or distributor nearest you. Powerware 3115 User’s Guide www.powerware.com ®... - Page 32 Troubleshooting Powerware 3115 User’s Guide www.powerware.com ®...