Table of Contents
Advertisement
.
. .
.
: '
I
I
' !
REPAIR
Engine
NOTE: The engine must be removed be-
fore the Field, Clamp or Clutch
Housing can be removed.
1.
Working under the mounting plate
(A) of
the cart, remove the screw (15), lock-
washer (80) and washer (34) holding
the clutch housing (2) to the cart.
See
Fig 29-1.
2. Still working under the mounting plate,
washers (9), and then pull the screws
remove the two nuts (61) and lock-
connect the red wire from the engine
(14) out of the base of the engine. Dis-
wires from the field. Pull the wires care-
lead (6). Disconnect the black and wire
fully through the grommets (66) before
removing the engine. See Fig 29-1 and
29-2.
3. Lift the engine carefully and place it
on a
work bench.
4. Remove the Field and Wiring Harness,
Clamp and Clutch Housing. See
pages 30 and 31,
5. Skip ahead to Reassembly, Step 1,
NOTE: All service to the engine must be
performed
by an- authorized
HONDA dealer.
w
Fig 2 S l
VIEW FROM UNDER ENGINE MOUNTING
PLATE ON UPRIGHT CART
VIEW FROM UNDER ENGINE MOUNTING
PLATE ON LO-BOY CART
!
Fig 29-2
"- -"
^ I
Advertisement
Table of Contents
