Table of Contents
Advertisement
. .
. .
.. .
.,.
..
.
.
.
....
..
.
. . .
. .
.
: , : .
. .
.
.
.. ..
. .
. .
SETUP
1.
Connect Hose and Gun. Refer to Fig 10-1.
a. Remove the plastic cap plug from the
filter outlet nip-
ple and screw the
50
ft.
(1 5.2 m) main fluid hose onto
the nipple.
b. Connect the whip end hose beiween the fluid hose
and the gun inlet connection.
c. Don't use thread sealant, and don't
install the spray
tip yet!
If you are supplying your own hoses and spray gun,
be sure the hoses are electrically conductive. That
the gun has a tip guard and that each part is rated for
to reduce the risk of serious bodily
injury caused by
at least 3000psi(270bar) Working Pressure. This is
static sparking, fluid injection or over-pressurization
and rupture of the hose or gun.
2. Two Gun Hookup. Refer to Fig 10-1. Remove the
cap from the secondary hose outlet and attach an ac-
cessory hose and gun to the 1/4 npsm(m) nipple.
CAUTION
To avoid damaging the pressure control, which
may
result in poor equipment performance and compo-
nent damage, follow these precautions:
1.
Always use nylon spray hose at least
50
ft.
(1 5.2 m) long.
2. Never use a wire braid hose as it is too rigid to act
3.
Never install any shutoff device between the fil-
4. Always use the main filter outlet for one gun
op-
as a pulsation dampener.
ter and the main hose. See Fig. 10-1.
eration. Never plug this outlet.
3. Fill
Packing NuWet-Cup. See Fig 10-1. Fill the
packing nut/wet-cup 1/3 full with Graco Throat Seal
Liquid
(TSL),
supplied.
4. Check the engine
oil
level.
Refer to the Honda en-
gine manual, supplied. This is a summary of the in-
should be almost overflowing. See
Fig 11-1. Add oil
formation: Remove one of the oil fill plugs; the oil
as necessary.
teraent oil. SAE
1 OW-40.
classified "FOR SERVICE
Recommended lubrication oil. Use a high quality de-
SE-or
S F ;
for regular use and forthe breaking-in of
a new engine.
SPRAY GUN
'
WHIP END HOSE
I
Fig 10-1
Advertisement
Table of Contents
