BenQ PL552 User Manual page 16

12 Parts and Functions
ID Remote Control
You can set the remote control ID when you want to use this remote control on one of
several different displays.
Press ID button. The red LED blinks twice.
1. Press ID SET button for more than 1 second to enter the
ID Mode. The red LED lights up.
Press the ID SET button again will exit the ID Mode. The
red LED lights off.
Press the digit numbers 0 ~ 9 to select the display you want to
control.
For example: press 0 and 1 for display No.1, press 1 and 1 for
display No.11.
The numbers available are from 01 ~ 255.
2. Not pressing any button within 10 seconds will exit the ID
Mode.
3. If an error pressing of buttons other than the digits
occurred, wait 1 second after the red LED lights off and
then lights up again, then press the correct digits again.
4. Press ENTER button to confirm. The red LED blinks twice
and then lights off.
• Press NORMAL button. The green LED blinks twice, indicating the display
is in normal operation.
• It is necessary to set up the ID number for each display before selecting its
ID number.