Block Configuration Errors - Honeywell XNX Technical Manual

Block Configuration Errors

Error
Accept New Alarm
Configuraiton
Accept New Excel Fault
Parameters
LinkConfiguration
SimulationActive
DeviceFaultState
Maint. Needed soon
Maint. Needed Now
Out Of Service
XNX Foundation Fieldbus Technical Manual
New alarm configuration for device is not accepted
at device. Select Accept Alarm Configuration
New Excel fault configuration for device is not
accepted at device. Select Accept Configuration
Not applicable
Device is in simulation state. Exit simulation being
performed on device.
Device is in fault state. Refer fault code to dignostic
fault on device.
Device is in warning state. Refer warning code to
dignostic warning on device.
Device is in fault state. Refer fault code to dignostic
fault on device.
Device not in service. Contact HA or force device in
Auto mode
If the XNX transmitter displays fault code F130 ("Option Communication
Failure"), it has detected the Foundation Fieldbus board but is not
communicating with it. Check all wiring. If the fault code persists, contact
Honeywell Analytics' Service Department for further instructions.
Solution
35