Table of Contents
Advertisement
rr
I
ADJUSTING 90 AND 45
DEGREE BEVEL STOPS
1 . D I S C O N N E C T T H E S A W F R O M T H E P O W E R
SOURCE.
2. Loosen bevel lock handle and move the cutting arm
allthe way to the right, then tighten the bevel lock handle'
3. Using a square (A) Fig. 25, place one end of the
square on the table and the other end against the blade'
Check to see if the blade is at 90 degrees to the table, as
shown in Fig. 25.
4. lf an adjustment is necessary, loosen locknut (B)
Fig. 26, and turn screw (C) until head of screw (C) con-
tacts casting (D) when blade is 90 degrees to the table'
Then tighten locknut (B).
5. Loosen bevel lock handle and move the cutting arm
all the way to the left bevel position and tighten bevel lock
handle.
6. Using a combination square (A) Fig. 27, check to see
if the blade is at 45 degrees to the table, as shown.
7. lf an adjustment is necessary, loosen locknut (E)
Fig. 28, and turn screw (F) until screw (F) contacts casting
(G) when blade is 45 degrees to the table. Then tighten
locknut (E).
8. These positive stops enable you to rapidly position
the blade at the 90 and 45 degree bevel angle to the
table.
ADJUSTING TENSION
OF CUTTINGHEAD
RETURN SPRING
The tension of the cuttinghead return spring has been
adjusted at the factory so the cuttinghead returns to the up
position after a cut has been made. lf it ever becomes nec-
essary to re-adjust the spring tension, proceed as follows:
1. Loosen locknut (A) Fig. 28A, and turn screw (B)
clockwise to increase or counterclockwise
to decrease
the spring tension. After the spring tension has been
adjusted, tighten locknut (A).
F i g . 2 B A
Fig. 25
Fig, 26
Fig.27
Fig. 28
1 2
Hide quick links:
Advertisement
Table of Contents
