Assembly - Ryobi Arctic Cove MLT0180 Operator's Manual

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Loose Parts section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Ensure all parts are properly and securely
assembled before use. Use of a product that may have
been improperly assembled could result in serious per-
sonal injury.
 If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
FEATURES
See page 12.
TOOLS NEEDED
See Figure 1, page 13.
 Phillips screwdriver
 Adjustable wrench
LOOSE PARTS
See Figure 2, page 13.
NOTE: Some parts are packed inside the base assembly.
A. Hood panel .............................................................. 3
B. Hood cap ................................................................. 1
C. Light assembly ........................................................ 1
D. Upper pole ............................................................... 1
E. Lower pole ............................................................... 1
F. Base assembly ......................................................... 1
G. Hardware bag (Not shown)...................................... 1

ASSEMBLY

HARDWARE
See Figure 3, page 13.
AA. Self-tapping Screw (M4 x 16 mm) ........................ 4
BB. Flat Washer, OD10.0xID4.4xT2.0mm ................. 28
CC. Cap Nut (M4) ....................................................... 12
DD. Machine Screw (M4 x 10 mm) ............................ 16
EE. Large Flat Washer, OD27xID14xT3.1
(for wing nut) ......................................................... 1
FF. Wing nut ................................................................ 1
GG. Spring clip ............................................................. 9
HH. Misting Hose Assembly ........................................ 1
ASSEMBLING THE HOOD PANELS AND CAP
See Figures 4 - 5, pages 13 - 14.
Remove the following items from the hardware bag:
BB - 24 Flat washers
CC - 12 Cap Nuts (M4)
DD - 12 Machine Screws (M4 x 10 mm)
NOTE: Hood panel hardware should only be hand-tightened
until all panels and the cap are assembled.
HOOD PANEL ASSEMBLY
 Put two of the hood panels together so that one overlaps
the other and the three screw holes line up.
NOTE: All three panels are identical.
 Slide washers over two screws.
 Insert the screws through the two outside panel holes.
 Slide a washer over the threaded portion of the screws.
 Thread a nut onto each screw and hand-tighten.
 Repeat on both sides of the remaining panels.
HOOD CAP-TO-PANEL ASSEMBLY
 Place the hood cap on top of the hood assembly so that
the six screw holes in the cap align with the remaining six
screw holes in the hood assembly.
 Slide washers over six remaining screws.
 Insert the screws through the six holes that connect the
panel assembly and cap assembly.
 Slide a washer over the threaded portion of the screws.
 Thread a nut onto each screw and hand-tighten.
 Tighten all 12 fasteners with a screwdriver and wrench.
5 — English