Honeywell STT750 Quick Start Installation Manual page 16

Screen # Units
(Writable for TC and
RTD sensor types only)
Range/Cal Units
(Visible for TC and RTD
sensor types only)
Sensor Type
(Database updates take
30 seconds to complete.
Do not interrupt power).
Sensor ID
(Database updates take
30 seconds to complete.
Do not interrupt power).
Sensor Wire Type
(Visible for RTD sensor
type only)
Sensor Lead Res
(Visible for RTD sensor
type and 2-wire RTD
type only)
Sensor Bias
Sensor Cal Lo Pt
Sensor Cal Hi Pt
Do Sensor Cal Lo
Do Sensor Cal Hi
Sensor LRV
Sensor URV
16
°C, °F,°R, Choose appropriate
K engineering units from list
Select the ranging and
°C, °F, °R,
calibration temperature
K
units
mV, TC,
RTD, Select Sensor Type.
Ohm
Select Sensor ID for Input
Sensor
selected Sensor Type.
Identifier
(Input selection).
2-Wire, Select the number of lead
3-Wire, wires for RTD and Ohm
4-Wire sensors.
Sensor lead wire
####.## resistance value. (only if
RTD type is 2 wire)
Bias on the measured
####.##
value
Calibration low point for
####.##
Sensor
Calibration high point for
####.##
Sensor
Executing this selection
corrects the Cal Low
Confirm
Point based on the input
measurement
Executing this selection
corrects the Cal High
Confirm
Point based on the input
measurement
Lower Range Value
####.##
representing 0% output
Upper Range Value
####.##
representing 0% output
Quick Start Installation Guide
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
Read Only
Parameter
Read Only
Parameter