Introduction To Portable Battery 2 - Guardian 715BBU Owner's Manual

Introduction to Portable Battery
Specification
Dimension (L x W x H)
Recharging Input (DC Jack)
Fully Charge Time
Cycle life
Operation Temperature
1. RISK OF EXPLOSIVE GASES:
• To reduce risk of battery explosion, follow ALL instructions and warnings on the battery pack
2. DO NOT touch eyes while working near batteries.
3. NEVER smoke or allow a spark or flame in the vicinity of battery or engine.
4. DO NOT drop ANY metal tools onto the battery. It might spark or short-circuit battery or other electrical part that may
cause explosion.
5. NEVER wear watches, rings, bracelets, or necklaces when working with car batteries. Batteries can produce a
short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.
Motion-Sensing Light
Motion and Ambient Light Sensor
LED Courtesy Light
26
Features
Built-in ultra-bright LED flash light with 3 lighting modes, High
●
beam /Fast Strobe / SOS.
LED indicators showing the battery and status.
●
Built-in protection features: over current protection; short circuit
●
protection,
over-charge protection.
DC power jack for pre-charging or recharging with a plug-in
●
transformer.
7'' x 3.2'' x 1.6'' (178 x 80 x 40mm )
DC15V / 1A
Approx. 4 hours
Approx. 3,000 times
o o
-10 C ~ 160 C
WARNING
!
Motion-Sensing Light
The Motion-Sensing Light is equipped with ambient light sensing
and motion (heat) detection. It will turn on automatically under
below conditions:
1. Upon normal door operation when ambient light is low, and will
remain on for about 3 minutes .
2. Motion is sensed when ambient light is low, it will turn on and will
remain on for about 3 minutes
3. During a power outage, it will turn on automatically upon door
operation with charged battery. (AC light bulb will not function)
overload protection, over-voltage protection,