Wiring Instructions - Guardian 715BBU Owner's Manual

Wiring Instructions

To prevent SERIOUS INJURY or DEATH from electrocution:
- Power MUST NOT be connected until instructed.
- NO exposed part of the wire should be visible outside of the terminal for proper connection.
Wire from accessories
Remove and discard pre-cut installation
Fig. 1
Wire Terminals
1
Screwdriver or similar tool
3
Fig. 2
!
2
1/2"
Wire shown in actual size
WARNING
In the following section, the Photo Eye Safety System and
Push Button will be connected to the Opener. Please read
and understand the wiring instructions before connecting
wires.
1. Remove the pre-cut installation on the open end of wire
from accessories. Wires MUST NOT be frayed and
connected properly as shown in Fig.1.
2. To connect a wire to an assigned terminal, use a small "flat
head" screwdriver to push in the orange tab on the Wire
Terminal as shown in Fig.2.
3. Insert approximately 1/2" (13mm) of the wire into the
terminal while pushing in the tab as shown in Fig.2.
4. Each accessory requires a pair of terminals, Each pair of
terminals MUST be connected with one white wire and one
striped wire (non-polarized) from the SAME accessory as
shown in Fig.2.
5. Check for proper connection by gently pulling on the wire.
The wire should not come out of the terminal. NO exposed
part of the wire should be visible outside of the terminal.
6. Use the insulated staples provided to secure the wires to
the wall and/or ceiling. Be careful not to damage the wires
while securing the staples.
Photo Eye Safety System
Door Control
Console
Min. 5 feet (1.5m)
above floor
13