Installing Light And Emergency Release Handle - Guardian 715BBU Owner's Manual

Installing Light and Emergency Release Handle

To prevent SERIOUS INJURY or DEATH from electrocution:
- Disconnect power cord before installing/replacing light bulb.
To prevent possible OVERHEATING or damage to Opener:
- Use ONLY A19 (E26) incandescent bulbs (100W max.).
- DO NOT use short neck or specialty light bulbs.
- DO NOT use halogen bulbs.
2
1
3
Fig.1
To prevent SERIOUS INJURY or DEATH from a falling garage door:
- In case of power failure or door obstruction, PULL EMERGENCY HANDLE to release door from Opener.
- When Emergency Release is in the released position, the door can be operated manually.
- To reconnect, flip the lever on the Trolley towards Opener, back to Connect position, it will reconnect
automatically upon pressing Door Control Console or Remote Control.
- DO NOT use Emergency handle to pull the door open or closed.
Emergency Release Handle
6 feet (1.83m) above floor
Fig. 2
12
!
1
2
WARNING
!
Lever
WARNING
To install light bulb as shown in Fig.1:
1.
2.
3.
To replace light bulb as shown in Fig.2:
1.
2.
Fig. 2
Notice
When replacing the light bulb, make sure the
bulb on the Opener has cooled down to
prevent injury.
Safety Notice
Mount the emergency release within reach, but at least 6 feet
above the floor and avoiding contact with vehicles to avoid
accidental release.
To attach the Emergency Release Handle:
1. Thread one end of the rope through the hole of the
Emergency Release Handle and secure with an overhand
knot.
2. Thread the other end of the rope through the hole in the
Trolley lever.
3. Measure the rope length so that the handle is 6 feet
(183cm) above the floor and is clear from the top of your
vehicle. Secure with a overhand knot.
Attach two clips to the lamp plate.
Install a standard A19 (E26) 100 watt
maximum light bulb.
Attach the Light Lens.
Press the release buttons and detach it
from the Opener.
Replace light bulb and reattach the Light
Lens.