Connecting Door Control Console - Guardian 715BBU Owner's Manual

Pro series 1/2hp
Hide thumbs Also See for 715BBU:
  • Faq (2 pages)
Table of Contents

Advertisement

Connecting Door Control Console

To prevent SERIOUS INJURY or DEATH from electrocution:
- Power MUST NOT be connected until instructed.
To prevent SERIOUS INJURY or DEATH from using the Door Control Console or Push Button and a
closing door:
- Install the Door Control Console or Push Button within sight of the door at a minimum height of 5 feet
(1.5m) above the floor. Make sure it is out of the reach of children and moving parts of door and
hardware.
- NEVER permit children to access the Door Control Console , Push Button or Remote Controls.
- Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.
- ALWAYS keep a moving door in sight until it's completely closed.
- NEVER cross the path of a moving door.
Screw #6 x1-3/8"
From Door Control Console
WARNING
!
Drywall Anchor
In this carton, a Door Control Console has replaced the standard
Door Control Console as the wired, illuminated door control to be
placed inside the garage.
To install the Door Control Console:
1. Lift the large actuator cover on door the control console and
the upper screw post is exposed.
2. Position the door control console at minimum height of 5 feet
(1.5m) above the floor to keep out of the reach of children,
within sight of door and free from any moving parts on the
door.
3. Mark the position of both upper screw post and lower screw
hole on the door control console.
4. Fasten the bottom screw to a solid surface with 1-3/8" screws.
If attaching to drywall or other hollow surface, drill 3/16" holes
and use the provided Drywall Anchors.
5. Align the bottom hole with the bottom screw. Slide the door
control down into place.
6. Repeat #4 to secure the door control console with the upper
screw.
7. Flip down the actuator cover back into place.
To Connect the Door Control Console to the Opener
Connect the pair of wires from the Door Control Console to the
pair of "PUSH BUTTON" terminals on the rear of the Opener.
Refer to Wiring Instructions on page 13 to ensure wires are
properly connected.
Door Control
Console
Min. 5 feet (1.5m)
above floor
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2211-d

Table of Contents