Stopping The Brew Process - Keurig B81 Owner's Manual

Set-Up & First Brew (continued)
SECTION 1

Stopping the Brew Process

If you need to stop the brewing after the process has started, press and
release the Power Button to turn the Brewer 'OFF'. The flow of coffee, tea or
hot cocoa will stop, the heating element will shut off and the lights
illuminating the Touch Screen and Water Reservoir will disappear.
NOTE: You may not get the brew size selected in your cup during for your next
brew. We recommend that you perform a cleansing brew with water-only after a
terminated brew. Then your NEXT brew will be the volume you have selected.
Adding Water
The Touch Screen of your Brewer will indicate when the water level in the
tank is low or if the Water Reservoir has been removed by displaying the
words "ADD WATER" (fig. 9). The white light in the Water Reservoir will also
blink when water needs to be added. The Brewer will not allow you to brew
when "ADD WATER" is displayed (fig. 9).
The Water Reservoir can be filled in two ways.
1.
2.
Note: In the back of the Water Reservoir
there is a finger indent for secure grip.
Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer,
then replace the Lid.
Remove the Water Reservoir from
Brewer by first removing Lid from the
Water Reservoir, then lifting the Water
Reservoir straight up and toward the left
of the Brewer. Fill with water. Place the
Water Reservoir back on the Brewer
and replace the Lid.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
Brewing Hot Water
Your Brewer is able to produce hot water for making hot cocoa from a
packet, for use in cooking, for making soups, etc. Simply follow the
instructions on page 6 — "Ready To Brew Your First Cup" without adding a
K-Cup.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water brew
cycle without a K-Cup.
Purging the Brewer
If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
If there is water in the Water Reservoir, remove the Lid, then lift the
1.
rinse and refill with water. Place the Water Reservoir back on the
Brewer and replace the Lid. (If there is no water in the Water
Reservoir, simply refill.)
Be sure the Brewer is turned on. Raise and lower the Handle on the
2.
Brewer without inserting a K-Cup.
The Touch Screen will display "READY TO BREW". Brew a Travel
3.
Mug (11.25 oz. serving) of water (do not use a K-Cup).
Repeat steps 2 and 3 two more times to completely purge water
4.
from inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866
8