Installing The Rsfc - Cisco Catalyst 5000 Series Installation And Configuration Note

Figure 2
Step 5
Step 6
Caution
that is partially seated in the backplane will cause the system to halt and subsequently crash.
Step 7

Installing the RSFC

This section describes how to install the RSFC in your Supervisor Engine II G or III G.
Note
Engine II Gs or Supervisor Engine III Gs.
Caution
Catalyst 5000 Series Installation Guide for ESD details including the locations of the ESD
connectors on the Catalyst 5000 series switches.
To install the RSFC in the supervisor engine, follow this procedure:
Step 1
Step 2
Step 3
Module Ejector Lever Operation
WS-X5540
SUPERVISOR ENGINE II G-SERIES CONSOLE
Keeping one hand under the carrier to guide the supervisor engine, carefully slide it into
the slot on the Catalyst 5000 series switch until the ejector levers click into place on the
chassis. Be sure to keep the module horizontal to the backplane and avoid touching any
of the components on the module.
Using the thumb and forefinger of each hand, simultaneously pivot in both ejector levers,
as shown in Figure 2, to fully seat the switching module in the backplane connector.
Always use the ejector levers when installing or removing switching modules. A module
Use a screwdriver to tighten the captive installation screws at the left and right sides of
the module.
To support redundant operation, both supervisor engines must be either Supervisor
Use a wrist strap or other grounding device to prevent ESD damage. Refer to the
If not already removed, remove the supervisor engine from the Catalyst 5000 series
switch (see the "Removing and Replacing the Supervisor Engine" section on page 8 for
instructions).
Place the supervisor engine on an antistatic mat or bag.
Remove the RSFC from its antistatic bag and install it on the supervisor engine (see
Figure 3). Be careful when seating the RSFC connectors to the supervisor engine.
Catalyst 5000 Series Route Switch Feature Card Installation and Configuration Note
WS-U5538-FEFX-MMF
PORT 1 PORT 2
CONSOLE
PORT MODE LINK LINK
RSFC CONSOLE
100 BASE FX
PORT 3 PORT 4
LINK LINK
Ejector lever
Installing the RSFC
Captive
installation
screw
11