Cisco Catalyst 5000 Series Installation And Configuration Note page 14

Configuring InterVLAN Routing on the RSFC
Task
Step 3
Step 4
Viewing and Saving the RSFC Configuration
To view and save the configuration after you make changes, perform this task in privileged EXEC
mode:
Task
Step 1
Step 2
Step 3
Bringing Up an RSFC Interface
In some cases, an RSFC interface might be administratively shut down. You can check the status of
an interface using the show interface command.
To bring up an RSFC interface that is administratively shut down, perform this task:
Task
Step 1
Step 2
Step 3
Configuring InterVLAN Routing on the RSFC
Note
you are not familiar with configuring Cisco routers, refer to the documentation for your router
platform.
These sections describe how to configure interVLAN routing on the Catalyst 5000 series RSFC:
•
•
•
•
•
Note
Configuration Examples" section on page 23.
14 Catalyst 5000 Series Route Switch Feature Card Installation and Configuration Note
Enter the commands to configure interVLAN
routing.
Exit configuration mode.
View the current operating configuration at the
privileged EXEC prompt.
View the configuration in NVRAM.
Save the current configuration to NVRAM.
Specify the interface to bring up.
Bring the interface up.
Exit configuration mode.
This section assumes familiarity with Cisco IOS software and Cisco router configuration. If
RSFC Configuration Guidelines, page 15
Accessing the RSFC from the Switch, page 15
Configuring IP InterVLAN Routing on the RSFC, page 15
Configuring IPX InterVLAN Routing on the RSFC, page 16
Configuring AppleTalk InterVLAN Routing on the RSFC, page 16
For a detailed configuration example of IP interVLAN routing on the RSFC, see the "RSFC
Command
(Refer to the appropriate configuration tasks later in this
publication.)
Router(config)#Ctrl-Z
Command
show running-config
show startup-config
copy running-config startup-config
Command
Router(config)#interface vlan interface_number
Router(config-if)#no shutdown
Router(config-if)#Ctrl-Z