Table of Contents
Advertisement
Getting started
Telephone base installation
Install the telephone base as shown below. Make sure that the electrical outlet
is not controlled by a wall switch.
If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone line, you must install a DSL filter between the telephone
base and the telephone wall jack. The filter prevents noise and caller ID
problems caused by DSL interference. Please contact your DSL service provider
for more information about DSL filters.
The telephone base is set for desktop use. If you want to change to the wall
mounting position, install the supplied wall mount bracket to the telephone base.
See page 10 for details.
1. Plug the small
end of the power
adapter into the
power jack at
the bottom of
the telephone
base.
6. Plug the large
end of the
power adapter
into a power
outlet not
controlled by a
wall switch.
Power
adapter
7. Raise the antenna.
If you want to change to the wall
�. Route the power cord through the
slot next to the telephone jack.
Telephone
line cord
DSL filter (not included),
required if you have DSL
high-speed Internet service.
7
�. Plug one end of
the telephone
line cord into the
telephone jack at
the bottom of the
telephone base.
4. Place the cords
into the channels.
5. Plug the other
end of the
telephone line
cord into a
telephone jack
or a DSL filter.
Advertisement
Table of Contents
