Section 5 - Commissioning; Select The Language; Flow Calibration; Filter Flush 3 - Zenith HydroTap G4 Installation Instructions Manual

Filtered boiling and chilled drinking water for residential use
Table of Contents

Advertisement

• Turn ON the water and check for any leaks.
• Turn the power ON at the GPO and at the side of the undersink unit
• If fitted, ensure the Booster is turned OFF. (The Booster is commissioned, later, at section 5.4)
• Familiarise yourself with the operation of the Tap, in preparation for use (See User Guide)
• Follow the Installation instructions below (and review Section C of the User Guide).
• After commissioning, the system may be customised by selecting further options in Section G -
Settings, within the User Guide.
5.1

Select the Language

-
Initial Commissioning screen
5.2
Filter Flush
-
Have a 10L bucket or similar container (not supplied) at the
ready to hold a quantity of water that will be ejected while the
Filter Flush Mode is in operation. Open the filter access door
on the front of the HydroTap and the filter cartridge will be
exposed. Located to the rear RHS of the cartridge is a flush
line, approx 600mm long and the flush line stop cock. Place
the valve end of the flush line into the 10L bucket or container
(not supplied).
5.3

Flow Calibration

-
802253NZ - HydroTap BC, BCHA -AV, AIO, Installation Instructions - Aug 2015 - V2.01
Section 5
Commissioning
1.
2.
3.
4.
5.
6.
7.
NOTE: For any subsequent fi lter changes or any operational
procedures, please refer to the HydroTap user guide, located
inside the fi lter housing access door.
Language selection screen
OPEN
Stop cock
operation
CLOSED
Turn the stop cock ON
Press [Start] [Stop] buttons to start and stop the filter flush.
Allow at least 10 litres of water to flush through the filter.
Once the filter flush is finished, Turn the stop cock OFF
then press [Stop] to end filter flush mode.
Press [Next] and the View screen will show the Flow
calibration mode.
Press the [Start] button and the tank will first empty then fill.
Upon completion the actual pulse will be displayed.
Press [Next] for the Boiling Calibration screen.
Page 33 of 36

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

802253nz

Table of Contents