Section 12: Commissioning - Zenith HydroTap G5 Home Series Quick Start Installation Manual

Command centre boiling, boiling / ambient models

Hide thumbs

Table Of Contents

Table of Contents

For a more detailed description of the commissioning process,

refer to the Command Center installation and user instructions

Install the filter cartridge

• Unpack filter cartridge, remove sanitary cap.

• Write today's date where shown on the label.

• Avoid touching the filter o-rings and

filter opening as this may cause bacterial

contamination of the cartridge.

• Moisten the o-rings with water.

• Open the filter door on the Command Centre.

• Align the front cartridge label to the left, and

push the new cartridge up into the filter head.

• Turn the cartridge a quarter turn anticlockwise

until it comes to a complete stop and locks,

with the front label facing forward.

Turn on the supplies & familarize yourself with the system

• Connect the mains electrical power cable to the supply.

• Turn the power and water on and check for any leaks.

• Familiarise yourself with the operation of the tap and GUI screen in

preparation for use, see the user guide.

Select the language, date / time & drain away options

• Initial commissioning screen touch

Language option.

• Touch the appropriate button to select

the language and units of choice.

• Touch the back arrow to go back to

previous menu.

• In the previous menu, touch the arrow to

begin the commissioning process.

Quick Start Installation Guide

806836NZ v1.02 02.22 G5 B BA Quick Start Guide